hello all,
this is my first post here, so i hope there is a way i can repair my g7200.
i got it today, buyed it untested some weeks ago. looks fine, nothing broken.
1) red button missing - are there 3d printed ones available?
2) power switch stuck - i repaired it in the last hour
3) dead. power supply - no voltages on secondary site. primary side seems dead. (fuse checked - ok, no bad soldering points. maybe the old capacitor)
things i have for repar: oscilloscope, multimeter, soldering iron and a isolating transformer.
a little knowledge in repairing is here (worked 1992-1995 @grundig austria) but missing lots in my brain about that.
found and downloaded the service manual -
but its without power supply/monitor part. all here. seems i am blind .. lol
videoconference possible

german and english.
thank you for reading
swasti
ps: i also own one or more g7000, g7400 and c64s.